They should be able to send you the replacement parts or ask you to bring in your tool for repairs. Try contacting the support team for Worx and then tell them about your problem in detail. If you are getting this problem, then replacing your faulty parts is the only solution. The magazine and internal parts of the tool can sometimes break, which results in the bits getting stuck inside them. Next, one more reason why your nail gun might be getting jammed can be that its compartment is damaged. It can be best that you lubricate the internal moving parts on your nail along this process as it prevents the bits from getting stuck. As long as you don’t damage any parts, the tool should start working after putting it back together. Once done, check where the bit is stuck and then remove it carefully. You can do this by removing the bolts holding the device together and then taking out the rest of its parts by opening the latches. If the bit stuck in your nail gun does not come out using the step mentioned above, then another thing that you can do is open up the entire tool. Make sure that you always use bits that are supported by your nail gun. To ensure that the problem does not appear again, people should check the type of nail bits they are installing. You can easily remove them using a sharp object and applying some force. Release the magazine and then check where the nail bits are stuck. Luckily, the magazine can be removed from your tool easily by opening it. In most cases, the nail bits get stuck inside the magazine, which causes the nail gun to get jammed. This can help you in dealing with the problem quickly while also keeping the tool protected from damage. The first thing that you should do when running into this issue is check where the nail bits are stuck. If you are running into the same problem, then going through this article should help you in finding some troubleshooting steps. Lately, people have been reporting that their Worx nail gun is jammed.
0 Comments
Leave a Reply. |